Teledyne Microwave Solutions

With the tube-to-tube performance consistency that is achieved with modern TWT manufacturing technology, power combining is a practical and relatively inexpensive means of achieving high power levels. Typical tracking of a TWT to a phase standard over an octave or greater frequency band when the absolute phase difference between the tubes is zeroed with an input phase shifter is ±20º (40º maximum imbalance between any two randomly selected tubes). When combined in a standard 4-port hybrid junction, such as a waveguide Magic Tee, the resultant combined power in Watts of two tubes with output powers P1 and P2 due to phase  and amplitude imbalance at the input ports is:

Ignoring combining losses (which are on the order of tenths of dB), two 300W TWTs with equal power output and 40º maximum phase imbalance combine to produce 530W (0.54 dB phase imbalance loss). If it were desired to combine a 400W TWT with a 200W TWT with the same maximum phase imbalance, the result would be 517W (0.65 dB phase and amplitude imbalance loss). Because of the relative insensitivity to amplitude imbalance, odd numbers of TWTs combine reasonably well. Power combining neither reduces the amplifier's tolerance to output mismatch nor its modulation fidelity. With the use of 180* hybrids, harmonic content can be reduced by at least 10 dB relative to the tube's stand-alone performance since in this case, harmonic is directed to the "lost-power" rather than to the "combined-power" port of the hybrid. Likewise, since TWT noise output is non-coherent and thus splits evenly between the two output ports of the hybrid, noise is reduced 3 dB per combination. Harmonics
Due to the wide bandwidth and high gain of the TWT, harmonics of the fundamental RF drive signal will appear in the output spectrum as the tube is driven into the non-linear region. Single octave TWTs typically have 3 dB or more low band edge harmonic separation while dual octave TWTs may exhibit harmonics equal to or greater than the fundamental. Higher harmonics also will be present, but to a lesser degree. Broadband TWTs may react to harmonics in the RF drive which, if sufficiently strong, can either enhance or degrade output power depending upon the relative phase angle between the harmonic and fundamental input signals. Noise
Noise in the output spectrum of a TWT results from the fact that electron emission from the cathode is a random process. Furthermore, the velocities of electrons emitted by the hot cathode have a Maxwellian distribution. TWT noise figure (in dB) is given by the following expression:

NF = 114 + NPO - 10 Log(BW) - Gss

-114 dBm/Mhz is the reference thermal noise caused by a room temperature termination at the TWT input. BW is the bandwidth relative to 1 Mhz over which the noise power output (NPO in dBm) is measured. Gss is the small signal gain in dB averaged over the bandwidth BW. Typical noise figures for medium power TWTs are 25 to 35 dB. Noise can be reduced by gating off the beam when signal transmission is not required either with a grid or focus electrode (FE). A grid cuts off noise to the thermal level. A focus electrode typically cuts gain to zero dB which generally results in noise output 25 to 35 dB above thermal. Most Teledyne CW TWTs are offered in both gridded and focus electrode gated versions. With modern design and fabrication techniques, the reliability of shadow grid versions is equal to or greater than their FE counterparts. Spurious outputs not correlated to the fundamental signal frequency are minimized by oscillation suppression techniques such as special helix attenuation patterns and pitch changes. Operation of the TWT into highly mismatched loads may increase spurious output since these suppression techniques are sometimes less effective in the presence of strong reflected signals.

Teledyne Microwave Solutions  |  11361 Sunrise Park Drive, Rancho Cordova, CA 95742

Phone: (800) 832-6869  |  © 2018 Teledyne Microwave Solutions. All rights reserved.

 Legal Notices & Terms and Conditions