Teledyne Microwave Solutions


<< Back to TWT Technical Information

If a large number of TWTs were simultaneously put into service, their survival rate history would be characterized by three distinct periods:

  • Infant Mortality
  • Random Failures
  • Wear-out

Infant mortality failures due to workmanship defects are effectively screened-out by “burn-in” before delivery. Random failures during the long middle period are characterized by the time constant MTBF (Mean Time Before Failure) which is a measure of the time to which about 37% (e-1) of the tubes will have survived. Cathode exhaustion triggers the point at which tubes wear-out and failure rates increase substantially. MTBF and life clearly are two different measures of a tubes history. Ideally, MTBF exceeds life by a substantial amount. In some cases, cathode life may be so long or the environment may be so severe that random failures account for the majority of tube removals. The best currently available measure of TWT MTBF is MIL-HDBK-217F Notice 2 which provides the following estimates:

Where P is the rated power in Watts (peak if pulsed) and F is the operating Frequency in Ghz (the geometric mean of the end points is used if the operating frequency ranges over a band). As an example, the 250W 0.8 to 2.0 Ghz M5670NO is predicted by this model to have MTBFs of 158,494 hrs for Air Conditioned sites, 52,831 hrs for unconditioned sites, and 11,321 hrs for ground mobile operation. This model is very simplistic and does not address failure drivers such as thermal and voltage stress gradients within the TWT, system VSWR, heater on – off cycling, power supply energy discharge during fault conditions, etc. Despite these concerns, experience with modern TWTs used on switching power supplies indicates that the MIL-HDBK typically under predicts MTBF by a factor of 22. A Safety and Set-up instruction booklet is provided with each Teledyne TWT. It contains good advice on set-up procedures to prevent infant mortality problems. The high voltage power supply should be designed to limit energy dissipation to substantially less than 10J with at least several ohms of series resistance in the TWT cathode connection. The tube also should be provided with adequate cooling so that temperatures are maintained within the recommended ranges under all operating conditions. Unlike SSAs, however, TWTs can operate for short periods at chill plate temperatures above their recommended level. TWTs are equipped with thermal interlocks to prevent permanent damage. Any TWT in this catalog can be special ordered for prolonged operation at temperatures reasonably beyond the recommended limits.


 
Teledyne Microwave Solutions  |  11361 Sunrise Park Drive, Rancho Cordova, CA 95742

Phone: (800) 832-6869  |  © 2017 Teledyne Microwave Solutions. All rights reserved.

 Legal Notices & Terms and Conditions